Bill C wrote:
Bill C wrote:
I assume there is leader line coming off the bar. Can't you tie figure-8 knots in the leader to adjust?
Hopefully, someone from Switch will step in and clarify.
topmick wrote:Surely there is somewhere to adjust / trim your lines ?
Nope. the leader lines are completely covered in PU.
Ony way I can come up with is tying knots in the pigtails...
I've used my Controller 3 quite a bit and have the steering lines attached to different leader line knots to compensate for stretch. Not much difference, but still different knots. The pigtails on my Controller 3 steering lines don't seem conducive for adjustments. Maybe they are different on the Controller 4.
There must be an explanation or compensating procedure.
Wonder if I can buy the Controller 4 bar and transfer my Controller 3 components.
I've done the same on my V2 bar. There's a one knot difference between the left and right side.
You can shorten the pigtails with knots, but that will weaken them too, so I'm not too sure that's a good idea.
There's no dedicated adjustment option on the V4, not the front lines, nor the backlines.
Switching out parts should be possible partially. But you'll probably need adjustments afterwards, and it's at your own risk offcourse.
But it should be possible to replace the V4 leader lines with the V3 ones. But there's a chance they are of different lengths, and you have to fix the leaders above the floaters so you don't run the risk of the leaders to slip from the rear side of the bar. Or you can possibly use the entire V3 bargrip including floaters on the V4. There should be enough room in the centerhole.