Nitro 6, Sensor 2 or Quad control

General Discussions
Post Reply
BernieTomic1
Posts: 3
Joined: Sat Feb 25, 2017 6:52 pm

Sat Feb 25, 2017 6:59 pm

Hi guys,

I am looking at the Nitro 6.
Would it work well with a Core Sensor 2 or North Quad control bar?
I am not super technical with bars yet, so not confident with a lot of remodeling.
YakAttack
Posts: 68
Joined: Sun Oct 25, 2015 7:09 pm

Sun Feb 26, 2017 4:30 am

Yes. No problem as long as your lines are of equal length with the bar pulled in
BernieTomic1
Posts: 3
Joined: Sat Feb 25, 2017 6:52 pm

Sun Feb 26, 2017 8:17 pm

Both those bar would be low Y type bars, with equal line lengths.
Both bars should thus work well with the Nitro 6? Is the Controller 3 also a low Y bar?
Are there any practical experiences?

Regards
Bernietomic
huili88
Posts: 148
Joined: Sun Nov 25, 2012 1:22 am

Mon Feb 27, 2017 1:32 am

I've used the core bar on my nitrov2. It works fine the nice thing about the core bar is the 2:1 depower requires less pressure but the twist release was a bit of a let down. I know the core bar has auto untwist but until you pull in on the bar the lines still look twisted and out of habit I would try to untwist manually which results in flag out.
YakAttack
Posts: 68
Joined: Sun Oct 25, 2015 7:09 pm

Mon Feb 27, 2017 3:18 am

Yes the controller 3 is low Y.
Post Reply